Abicor Binzel ABIPLAS WELD 100 W Betriebsanleitung Seite 41

®
ABIPLAS WELD
Fault
Pilot arc does not ignite
Main arc does not ignite • Distance between the workpiece and
Torch body or power
source cable are
overheating
Pilot or main arc burning
skewed
Tab. 12 Troubleshooting
11 Disposal
BAL.0092 • 2017-06-06
Cause
• Tungsten electrode and plasma
nozzle make contact
• Distance between tungsten electrode
and plasma nozzle too large
• Tungsten electrode is worn out or
oxidised
the torch too large
• Pilot arc does not burn
• Connection between the workpiece
and power source is interrupted
• Inadequate coolant flow
• Welding current too high
• Coolant hose or liquid-cooled power
cable constricted or sealed
• Plasma nozzle not properly tightened • Tighten plasma nozzle
• Tungsten electrode worn out
• Plasma nozzle worn out
• Centring ceramics missing or
damaged
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards
and guidelines.
11 Disposal
Troubleshooting
• Re-adjust the electrode
• Re-adjust the electrode
• Re-sharpen and align the
electrode
• Shorten the distance
• Ignite the pilot arc
• Connect the earth cable
• Check and repair the coolant
recirculator
• Reduce the welding current
• Remove constriction and
replace cable assembly if
necessary
• Sharpen the tungsten electrode
• Replace the plasma nozzle
• Replace the centring ceramics
EN - 21