Abicor Binzel ABIPLAS WELD 100 W Betriebsanleitung Seite 31

®
ABIPLAS WELD
6.1 Setting up the ABIPLAS
1 2
12 11
1 Alignment gauge
2 Gas nozzle
3 Plasma nozzle
Fig. 3 Overview of the wear parts
1–2 3
Fig. 4 Steps for setting up the ABIPLAS
BAL.0092 • 2017-06-06
®
WELD torch body
3 4
10
4 Gas diffuser
5 Insulating ring
6 Torch body
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the tungsten electrode tip.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
4
5
®
WELD
1 Insert the blunt end of the tungsten electrode into the back cap to a depth
of about 5 mm.
2 Screw the back cap into the torch body from above until reaching the
end stop.
3 Unscrew the back cap half a turn anti-clockwise.
5 6 7
7 Centring ceramics
8 Tungsten electrode
9 Back cap
6
torch body
6 Putting into operation
8
10 Long plasma nozzle
11 Long gas nozzle
12 Long alignment gauge
7–8
9
EN - 11
9