Abicor Binzel ABIPLAS WELD 100 W Betriebsanleitung Seite 34

6 Putting into operation
6.3 Connecting the coolant
1
4
1 Coolant return hose
2 Coolant supply hose
Fig. 6 Connecting the coolant
EN - 14
WARNING
Risk of burns
If the coolant level is too low, the plasma welding torch will overheat.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Ensure that the coolant supply and return hoses have been correctly
installed. Coolant supply = blue, coolant return = red.
• Do not use deionised or demineralised water as coolant or for leak and
flow tests.
This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using
ABICOR BINZEL BTC coolant.
 Please consult the applicable safety data sheet.
2
3 Coolant recirculator
4 Control lead
®
ABIPLAS WELD
3
BAL.0092 • 2017-06-06