Menu Overview - KERN KIB-TM Betriebs Und Installationsanleitung

8.2 Menu overview

Menu block Menu item
Main menu Submenu
PO CHK nEt H
Weighing with
nEt L
tolerance range,
see chap. 7.7
PCS H
PCS L
BEEP
rELAY
1
P1 rEF
A2n0
Zero point
settings
0AUto
0rAGE
0tArE
P2 COM MODE
Interface
parameter
KIB-TM-BA_IA-e-1811
Available settings / explanation
Upper limit value „Tolerance check weighing", input see
chap. 7.7.1
Lower limit value „Tolerance check weighing", input see
chap. 7.7.1
Upper limit value „Tolerance check counting", input
see chap.
7.7.2
Lower limit value „Tolerance check counting", input
see chap.
7.7.2
Acoustic signal for weighing with tolerance range
no
switched off
Audio sound when weighed load is within
ok
tolerance limits
Audio sound when weighed load is beyond
nG
tolerance limits
Relay pilot light
on
oFF
Automatic zero point correction (Autozero) by changing the
display, digits selectable (0, 0.5d, 1d, 2d, 4d)
Zero setting range
Load range where the display after switching-on the
balance is set to zero. Selectable 0, 2, 5, 10, 20, 30, 50,
100 %
Zero setting range
Load range where the display is set to zero by pressing
. Selectable 0, 2, 4, 10 , 20* , 50, 100%.
Automatic taring „on / off", taring range adjustable in menu
item „0Auto".
CONT S0 off Continuous data output,
selectable „sending 0", yes / no
S0 on
ST1 One output for stable weighing value
STC Continuous data output of stable weighing
values
PR1
•
Output after pressing
•
Precondition for alibi memory
PR2 Manual totalizing, see chap. 7.8
Press and the weighing value will be added
to the summation memory and issued.
37