Makita BLM430 Bedienungsanleitung Seite 8

Battery converters (optional accessory)
WARNING:
Before installing or removing the battery converters
•
BCV01/BCV03, remove the lock key.
BCV01 (optional accessory)
WARNING:
When using the BCV01, never attach it to any part
•
of your body. Attaching the BCV01 to any part of
your body may cause a serious injury.
Fig.2
Slide the battery converter BCV01 into the installation
hole until it stops.
Fig.3
Open out the battery cover on the mower and then slide
all the way and click the product mounting adapter of the
BCV01 into the battery port on the mower.
Run the cord of the BCV01 through the slit in the battery
cover and close the battery cover.
Fig.4
Fit the cord of the BCV01 into the upper holders on the
handle.
NOTE:
When using the battery converter BCV01 (optional
•
accessory), hook the power cord to the designated
holder on the mower. Failure to do so may cause
the cord to be cut off.
To remove the BCV01 from the mower, open out the
battery cover and then press the hook on the battery
mounting side of the BCV01.
BCV03 (optional accessory)
Fig.5
Open the battery cover and click in the BCV03 into the
battery port on the mower.
Close the battery cover.
1. Battery converter (BCV03)
014473
To remove the BCV03, press on the hook of the BCV03
and withdraw it with both hands.
Power switch action
•
NOTE:
•
•
This mower is equipped with the interlock switch and
handle switch. If you notice anything unusual with either
of these switches, stop operation immediately and have
them checked by your nearest Makita Authorized
Service Center.
Fig.6
1.
1. Switch button
2. Switch lever
012603
2.
3.
4.
5.
6.
1
8
WARNING:
Before inserting the battery cartridge in the
tool, always check to see that the switch lever
actuates properly and returns to the original
position when released. Operating a tool with a
switch that does not actuate properly can lead to
loss of control and serious personal injury.
Trying to mow much grass at a time may not allow
the motor to start due to the overload. At this time,
change the mowing height to higher level to restart.
The mower does not start without pressing the
switch button even if the switch lever is squeezed.
Insert the lock key into the interlock switch.
1
Depress the switch button.
Pull the switch lever toward you while depressing
the switch button.
Release the switch button as soon as the motor
starts running. The mower will continue to run until
you release the switch lever.
Release the switch lever to stop the motor.
When not in use, remove the lock key. Store the
lock key in a safe place out of reach of children.
2