Makita BLM430 Bedienungsanleitung Seite 10

ASSEMBLY
WARNING:
Always be sure that the lock key and battery
•
cartridge are removed before carrying out any
work on the mower. Failure to remove the lock
key and the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the handle
WARNING:
When installing handles, position the wires so that
•
they are not caught by anything in between the
handles.
1. Loosen the clamping screws (two pcs).
3
1. Lower handle
2. Groove on the deck
3. Clamping screw
012385
Expand the lower handle to its both sides and with it
expanded in that position pivot it backward and then fit it
in the groove in the deck.
2. Tighten the clamping screws on both sides to
secure the lower handle.
Fig.8
Fig.9
3. Raise the upper handle and align the screw holes
in the upper handle with those in the lower handle
and then secure it with the supplied screws and
clamping nuts.
NOTE:
At this time, keep a firm grip on the upper handle
•
so that it does not drop off your hand.
Fig.10
Fig.11
NOTE:
Install the upper handle so that the direction of the
•
upper handle and the power supply cord are
positioned as shown in the figure.
Fig.12
NOTE:
The upper handle has two holes each on both
•
sides. Using the different position holes for the
screws and clamping nuts allows the handle height
adjustment.
Removing or installing the blade
WARNING:
Always remove the lock key and battery cartridge
•
when removing or installing the blade. Failure to
remove the lock key and battery cartridge may
cause a serious injury.
The blade coasts for a few seconds after releasing
•
the switch. Make sure that the blade has come to a
1
complete stop.
Always wear gloves when handling the blade.
•
2
1. Screwdriver
2. Blade
3. Bolt
012304
1. Put the mower on its side so that the mowing
height adjusting lever is placed on the upper side.
2. To lock the blade, insert a screwdriver available or
the similars in market into a hole in the mower.
3. Loosen the bolt counterclockwise with the wrench.
10
2
1
3