Operation - auna 10031854 Bedienungsanleitung

OPERATION

Plug the 5.5mm DC plug of provided AC to DC power adapter into "DC
INPUT Socket (3)" which located on back of BT Kitchen clock device.
Clock setting
1 When first time plug the power adaptor, the clock should show "00:00"
on the display, then manual clock time adjustment is required.
2 Short press the „Clock/ST (10)" button to entry time format set.
3 The LED display will show blinking "24H" or "12H" for 6 seconds (factory
defaulted is "24H").
4 Rotates the "Adjustment (16)" button to " " or " " for selects the desired
time format:
5 Short press the "Adjustment (16)" button to confirm the time format set
and go for hour set, the number of hour will blinking;
6 Rotates again the "Adjustment (16)" button to " " or " " for selects the
hour time as current time;
7 Short press again the"Adjustment (16)"button to confirm the hour time
set and go for Minute set. The number of minute will blinking;
8 Rotates again the "Adjustment (16)" button to " " or " " for selects the
minute time as current time and short press the "Adjustment (16)"
button to confirm the minute time set.
9 The clock set adjustment is completed and clock time is showing on
LED display.
Note: Since the device has a AG13(LR44) button cell which will ensure
the time is maintained even during power outage. The clock time will
not be maintained if the backup battery runs out. In this case the clock
should show "00:00", a new cell is needed to replace. Then manual clock
time adjustment is required.
EN
23