GF SIGNET 9900 Bedienungsanleitung Seite 18

System Setup
All of the basic system setup functions
are automated in the 9900 for almost all
sensors and sensor electronics.
This includes assigning the sensor
connected to the 9900, and confi guring
the display for the sensor.
When the 9900 is fi rst powered on, it will
attempt to determine the sensor type
connected when ENTER is pressed
(unit will display LOOKING FOR).
If no sensor is attached to the 9900, the
words "TYPE" and "FLOW" are displayed.
If the 9900 does not identify your sensor
type correctly, use the ▲ and ▼ keys to
select your sensor type.
Press ENTER to save selection.
Refer to the 9900 Operating Instructions (3-9900.090) for detailed instructions
on calibrating your unit for your individual sensor type and adjusting your
Relay/Open Collector settings.
18 9900 Transmitter Start-Up Guide
System Setup: Step 3
Assign the appropriate sensor type for your system.
ENTER
Sensor Choices
NOTE: The 9900 displays the
BATCH instrument type ONLY
if the Batch Module is installed.
ENTER