Troubleshooting - Klarstein 10032506 Handbuch

TROUBLESHOOTING

Do not repair or disassemble the air conditioning by yourself. Unqualified repair will
lead to failure of the warranty card, and may cause damage to users or their properties.
Problems Reasons
The air There is no electricity.
conditioning The water-full indicator will
does not work flash.
The ambient temperature is too
low or too high.
In cooling mode, the room
temperature is lower than the
set temperature; in heating
mode, the room temperature
is higher than the set
temperature.
In dehumidification mode, the
ambient temperature is low.
The cooling There is direct sunlight.
effect is not Doors or windows are open;
good. there are a lot of people; or in
cooling mode, there are other
sources of heat.
The filter screen is dirty.
The air inlet or outlet is
blocked.
Big Noise The air conditioning is not
placed on a flat surface.
Compressor Frost production starts.
does not work Overheat protection starts.
Solutions
Turn it on after connecting it to
a socket with electricity.
Discharge the water inside.
Recommend to use the
machine in at the temperature
of 7-35 °C (44-95 °F).
Change the set temperature.
The machine is placed in
a room with an ambient
temperature of greater than
17 °C (62 °F).
Pull the Curtain.
Close doors and windows,
and add new air conditioning.
Clean or replace the filter
screen.
Clear obstructions.
Put the air conditioning on a
flat and hard place (to reduce
noise).
Wait for 3 minutes until the
temperature is lowered, and
then restart the machine.
EN
29