Operation; Specifications - Monacor PA-700 Montageanleitung

shown in fig. 3-8). The positive connection of the
speaker cable is always specially marked.
The total load of all speakers must not exceed
35 W when using PA speakers with 100 V audio
RMS
transformer (fig. 8), as otherwise the amplifier will be
overloaded. This may result in amplifier damage.
5.3 Priority Switch
A priority switch (make contact) can be connected to
the PRIORITY screw connections (8). Channels MIC 2
and PHONO/AUX can be faded out when this priority
switch is kept depressed so that only announcements
via MIC 1 can be heard. After releasing the priority
switch, channels MIC 2 and PHONO/AUX are softly
faded in again.
5.4 Power Supply
Finally, connect the amplifier to a power mains supply
(230 V~/50 Hz).

6 Operation

1) Turn the MASTER VOLUME control (4) to zero
before switching on. Switch on the amplifier via the
POWER switch (5).
2) Set the Phono/AUX selector (10) to the AUX posi-
tion. The selector must be set to PHONO position
only if a turntable with magnet system is used.
3) Slightly turn up the MASTER VOLUME control (4).
Adjust the desired volume in relation to each other
via MIC 1, MIC 2 (1), and PHONO/AUX (2). Set all
controls which are not connected to a source to
zero.
4) Adjust the tone with the controls 150 Hz (bass),
1 kHz (midrange) and 6 kHz (treble) and the total
volume with the MASTER VOLUME control (4).
5) If desired, fade the microphones in and out with the
MIC 1 and MIC 2 (1) controls resp. the music
source with the PHONO/AUX control (2).
6) If a priority switch for microphone MIC 1 is con-
nected, keep it pressed during announcements.
Channels MIC 2 and PHONO/AUX will be faded
out and only the announcement will be heard. After
releasing the priority switch, channels MIC 2 and
PHONO/AUX will be softly faded in again.

7 Specifications

Output Power RMS: . . . . . 35 W
THD: . . . . . . . . . . . . . . . . . 5 % (35 W)
Outputs
Speakers: . . . . . . . . . . . 4/8/16 Ω, 100 V
Inputs
MIC: . . . . . . . . . . . . . . . 2 x 2 mV/5 kΩ (for low
PHONO: . . . . . . . . . . . . 3 mV/50 kΩ (RIAA)
AUX: . . . . . . . . . . . . . . . 150 mV/3 kΩ
Frequency Range: . . . . . . 65-16 000 Hz, ±3 dB
Tone Control
Bass: . . . . . . . . . . . . . . . ±12 dB/150 Hz
Midrange: . . . . . . . . . . . ±12 dB/1 kHz
Treble: . . . . . . . . . . . . . . ±12 dB/6 kHz
S/N Ratio: . . . . . . . . . . . . . > 55 dB
Power Supply: . . . . . . . . . . 230 V~/50 Hz/92 VA
Dimensions (W x H x D): . . 290 x 85 x 230 mm
Weight: . . . . . . . . . . . . . . . 4 kg
According to the manufacturer.
Subject to technical change.
, 70 W max.
RMS
impedance microphones)
GB
7