1 Vorarbeiten
1.1 Ausbau des Türdichtungsrahmen mit 3WX 3186–0JA00
-
Schrauben (8 Stück) des Türdichtungsrahmens vom Schal-
ter abschrauben.
Fig. 2
1.2 Ausbau des Bedienpultes
3.1
3.3
3.2
Fig. 3
Hinweis:
Sofern vorhanden, braucht der am Bedienpult montierte
Türdichtrahmen nicht demontiert werden!
- Befestigungsschrauben 3.2 herausschrauben
- Handhebel 3.3 nach vorne klappen
- Bedienpult 3.1 unten vorklappen (a) und nach oben abnehmen
(b)
2
1 Preparatory work
1.1 Removing the door sealing frame with 3WX31 86–
0JA00
-
Remove the 8 screws for the door sealling frame from the
breaker.
1.2 Removing the control panel
b
a
Note:
It is not necessary to remove the door sealing frame fitted to the
control panel!
- Undo fixing screws 3.2
- Pull operating handle 3.3 forwards
- Pull control panel 3.1 forwards at the bottom (a) and remove
upwards (b)