Operation; Switching The Product On / Off; Adjusting The Time; Programme Irrigation 1 And 2, Interval - FLORABEST 296225 Bedienungs- Und Sicherheitshinweise

Note: Such mains adapters are available from
speciality retailers.
Check the water connection type available. The
product is fitted with a union nut
with a 33.3 mm thread (G 1"). For a tap with a
26.5 mm thread (G ¾") use the adapter sup-
plied .
12
Insert the filter into the union nut
11
depicted in Figure A..
For a 26.5 mm thread (G ¾"): Screw the
adapter onto the tap. Do not use any tools
12
for this purpose.
Screw the union nut
tap or the adapter. Do not use any tools for this
purpose.
Screw the coupling
tion . You can then connect a hose to the
9
coupling .
13
Open the tap.
Attention! If defects / leaks arise when using
the adapter , the thread of the tap must be
12
wrapped using sealing tape.
Open the protective cover to service the pro-
duct . Close the protective cover
3
afterwards.
Programme irrigation as described in the
chapter „Operation".

Operation

Irrigation can be fully automated at any time of the
day using the irrigation controller. A sprinkler, sprinkler
system or drip irrigation system may be connected.
The irrigation controller automatically carries out
irrigation at the respective programmed start time
and for the programmed duration. Take the season
and time of the day into consideration when pro-
gramming. Evaporation and water consumption is
lowest early in the morning or late in the evening.
10 GB
for a tap
1
as
1
onto the thread of the
1
onto the hose connec-
13
fully
3

Switching the product on / off

(Fig. 1)
Press and hold down the
for approx. 2 seconds to switch it on or off.
8
Note: Automatic irrigation does not occur if
the product is switched off (see Fig. C). In a
switched-off state, however, irrigation may
occur manually (as described in the chapter
„Manual irrigation.").
Adjusting the time (Fig. 2–6)
1. Switch on the product. Press and hold down the
ON / OFF button
2. Press and hold down the
approx. 2 seconds. The system time's hour
display will flash.
3. Set the hour by turning the rotary control
4. Press the button
display will flash.
5. Set the minutes by turning the rotary control
6. Then press the button
Programme irrigation 1 and 2,
interval (Fig. 7–29)
Press and hold down the
2 seconds to activate programming mode. You
can either apply all settings one after the other,
or switch between the following setting options
by repeatedly pressing the
Start time irrigation 1
Duration irrigation 1
Start time irrigation 2
Duration irrigation 2
ON / OFF button
for approx. 2 seconds.
8
button for
4
6
. The system time's minute
4
again to save.
4
button for approx.
5
button :
5
.
.
6