Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Clean the tool after completion of your work. Apply some grease
onto the drilling spindle thread. The ventilation slots must always be
clean and unclogged. Make sure that now water gets into the tool
during cleaning.
After the first 150 hours of operation, the gearing oil must be
changed.
Gearing oil changes bring about an essential increase of the tool's
lifetime.
After approx. 250 hours of operation, the carbon brushes must be
checked and, if necessary, be replaced by an authorized specialist
(use only original carbon brushes).
Once per quarter of a year, an electrical specialist should check the
switch, cable and plug.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages in transit, the tool is supplied in a sturdy packing. The
packing as well as the tool and its accessories are made of recyclable
materials which enable environmentally friendly and sortwise disposal by
the local reception points.
Only for EU countries
Do not dispose of electric tools together with household
waste material!
In observance of European Directive 2012/19/EU on waste
electrical and electronic equipment and its implementation
in accordance with national law, electric tools that have
reached the end of their life must be collected separately
and returned to an environmentally compatible recycling
facility.
Noise Emission / Vibration
The indication of noise emission is measured according to DIN 45 635, part
21. The level of acoustic pressure on the work place could exceed 85 dB
(A); in this case protection measures must be taken.
Wear ear protectors!
The typical hand-arm vibration is below 2.5 m/s².
Measured values determined according to EN 60 745.
27
Werbung
