Dust Protection - Eibenstock ESD 162 Originalbetriebsanleitung

Dust Protection

Dust from material such as paint containing lead, some wood species,
minerals and metal may be harmful. Contact with or inhalation of the dust
may cause allergic reactions and/or respiratory diseases to the operator or
bystanders. Certain kinds of dust are classified as carcinogenic such as oak
and beech dust especially in conjunction with additives for wood
conditioning (chromate, wood preservative). Material containing asbestos
must only be treated by specialists.
Where the use of a dust extraction device is possible it shall be used.

To achieve a high level of dust collection, use industrial vacuum cleaner

DSS 35 M iP for wood and/or minerals together with this tool.
The work place must be well ventilated.

The use of a dust mask of filter class P2 is recommended.

Trouble Shooting
In case of breakdown, switch the motor off and disconnect
it from the power. Repairs of the electrical parts may only
be performed by an authorised service specialist.
Error
Machine does not
work.
motor runs, drill bit
does not rotate
drilling speed too
slow
motor shuts down
Possible Cause
mains current supply interrupted
line cord or plug damaged
switch damaged
gearbox damaged
drill bit damaged
drill bit polished
the tool stops
overload protection of the motor
has reacted
carbon brushes are worn out -
auto-stop brush switch off
Error Recovery
plug in another electric
appliance and check the
functioning
have it checked by an electric
specialist and replaced if
necessary
have it checked by an electric
specialist and replaced if
necessary
have the tool repaired by an
authorised service workshop
check if drill bit is damaged and
replace it if necessary
sharpen the drill bit with a
sharpening stick while using the
flush
lead the tool in a straight
manner
discharge the tool and restart it
by pressing the switch a couple
of times
both brushes must be replaced
with original brushes by an
electrical specialist
23