Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Always lead the mains and extension cables as well as the dedusting
hose from the tool to the back.
Electrical tools have to be inspected visually by a specialist in regular
intervals.
On using the tool, in no case cooling water may seep into the motor or
the electric components.
If water comes out of the drainage hole at the gear neck, stop your
work and have the tool repaired by an authorised service centre.
Perform overhead drilling only with suitable protective appliances
(water catcher).
After interruption of your work, restart the tool only after having made
sure that the drill bit is moving freely.
The tool may be used only in two-hand operation or with the drill rig.
Keep the handles dry, clean, and free of oil and grease.
Do not touch rotating parts.
Persons under 16 years are not allowed to use the tool.
During use, the user and other persons standing nearby have to wear
suitable goggles, helmets, ear protectors, dust mask, protective cloves
and boots.
During manual operation, always hold the tool with both hands
and be fall-safe. Consider the tool's reaction torque in case of
blocking.
Always work in a carefully considered way and do not use the tool
if you are lacking consideration.
During manual operation, work with a special circumspection
when dry drilling with dimensions between 100 and 200 mm !
For further safety instructions, see the enclosure.
Electrical Connection
The ETN 162/3 is made in protection class 2. For protection purposes the
machine can only be run with a GFCI. The machine is standard equipped
with a PRCD switch in the cord which allows to connect the unit direct to a
socket.
Attention!
The PRCD protective switch must not lay in water.
!
PRCD protective switches must not be used to switch the tool on
and off.
Before starting your work, check the proper function by
pressing the TEST button.
20
Werbung
