Fork Installation - Rock Shox Recon Handbuch

Recon & Tora User Manual

FoRk insTallaTion

It is extremely important that your RockShox fork is installed correctly by a qualified bicycle mechanic.
improperly installed forks are extremely dangerous and can result in severe and/or fatal injuries.
1. Remove the existing fork from the bicycle and the crown race from the fork. Measure the length of
the fork steerer tube against the length of the RockShox steerer tube. The RockShox steerer tube
may need cutting to the proper length. Make sure there is sufficient length to clamp the stem (refer
to the stem manufacturer's instructions).
DO NOT ADD THREADS TO ROCKSHOX THREADLESS STEERERS
THE STEERER TUBE CROWN ASSEMBLY IS A ONE-TIME PRESS FIT.
REPLACEMENT OF THE ASSEMBLY MUST BE DONE TO CHANGE THE
LENGTH, DIAMETER OR HEADSET TYPE (THREADED OR THREADLESS).
DO NOT REMOVE OR REPLACE THE STEERER TUBE. THIS COULD RESULT
IN THE LOSS OF CONTROL OF THE BICYCLE WITH POSSIBLE SERIOUS
AND/OR FATAL INJURIES.
. Install the headset crown race (29.9mm for 1 1/8" steerers) firmly against the top of the fork crown.
Install the fork assembly on the bike. Adjust the headset until you feel no play or drag.
3. Install the brakes according to the manufacturer's instructions and adjust brake pads properly. Use
the fork only with disc style brakes mounted through the provided mounting holes. Do not use any
cantilever brake other than those intended by the brake manufacturer to work with a hangerless
brace.
4. Forks designed for standard quick releases: adjust the front wheel quick release to clear the
dropout's counter bore. The quick release nut must be tightened after the wheel is properly seated
into the dropout's counter bore. Make sure four or more threads are engaged in the quick release
nut when it is closed. Orient the quick release lever in front of and parallel to the lower tube in the
locked position.
5. Keep in mind tire clearance as you choose tires. Maximum size is:
Be sure to check this diameter whenever you change tires. To do this, remove air pressure and
compress the fork completely to make sure at least 5 mm of clearance exists between the top of the
tire and the bottom of the crown. Exceeding maximum tire size will cause the tire to jam against the
crown when the fork is fully compressed.
PoPloc RemoTe insTallaTion
The PopLoc Remote Lockout lever allows the rider to control the movement of their suspension fork
without removing their hands from the handlebars. Specific left and right PopLocs are available. If
needed, remove the grip, brake lever, and shifter from the handlebar. If you are unfamiliar with the
removal of these items, please consult the manufacturer's instructions.
1. Slide the Poploc onto the handlebar.
. Re-install the shifter, brake lever, and grip on the handlebars. If you are unfamiliar with the
installation of these items, please consult the manufacturer's instructions. Always adhere to the
recommended torque specifications for these items.
3. Position the PopLoc as desired on the handlebar and tighten the clamp bolt to 0 in-lb (.5 Nm)
©SRAM Corporation • 008
w a r n i n g
fork
Recon
Tora
max tire size (installed)
.5"
.5"
English
5