Dmx Mode - Cameo H2 FC Bedienungsanleitung

Dimmer Curve = Dimmer curve
Dimmer = Dimmer response
Response
PWM Frequency = Configuration of LED PWM
frequency
Autolock = Automatic locking of the
controls
Calibration = Colour calibration
Wireless = W-DMX settings
Power = Operating mode
Software Update = For service purposes only
Factory Reset = Reset to factory settings
Factory Reset = Reset to factory settings
WC except User Colors
SYSTEM INFORMATION (System Info)
Starting from main display 1, press MENU to enter the main menu. Using UP and DOWN, select the menu item System Info and confirm
with ENTER.
Menu
DMX Address

DMX Mode

DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for accessing the system information (see table, selection with UP and DOWN, confirm with ENTER,
change status with UP and DOWN, confirm with ENTER).
System Info
Firmware = Displays device firmware
12
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower DMX values
and broadly adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjusted at lower DMX values
and finely adjusted at higher DMX values
S-Curve Light intensity can be finely adjusted at lower and higher
DMX values and broadly adjusted at medium DMX values
LED Lamp responds abruptly to changes in DMX value
Halogen Spotlight behaves like a halogen spotlight with soft bright-
ness changes
800 Hz/1200
Hz/2000 Hz/
3600 Hz/12
kHz/25 kHz
On Automatic locking of the controls after approximately 30
seconds of inactivity. Display shows: "LOCKED"
To unlock: Press and hold UP and DOWN simultaneously for
approx. 5 seconds
Off Automatic locking of the controls is deactivated
Type Factory Factory calibration of R, G, B, A and L
Calibration (across all modes)
User Individual colour calibration. Cross-mode brightness setting
Calibra- of R, G, B, A and L with values
tion from 000 - 255.
RAW R, G, B, A and L with maximum value 255
W-DMX On/Off On = W-DMX activated
Off = W-DMX deactivated
Reset Press ENTER = Reset pairing with a transmitter and ready
for new pairing
Constant Constant brightness over long periods
Maximum Maximum brightness
Reset? Reset to factory settings:
Perform reset with ENTER, cancel with MENU
WC Reset? Reset to factory settings except User Colors
Perform reset with ENTER, cancel with MENU
Firmware
V1.xx