Battery Replacement; Practical Tips; Emissivity Values - Velleman DVM8810 Bedienungsanleitung

e) Laser Pointer
Hold the ON/HOLD key and press the LASER key. Press the button again to turn the laser off.
7. Operating Instructions
Hold the meter by its handle and point the IR sensor at the object whose temperature you wish to measure. The
meter automatically compensates for temperature deviations from ambient temperature. Keep in mind that it will take
up to 30 minutes for the device to adjust if you go from measuring very cold temperatures to measuring extremely hot
ones. In this case, several minutes will pass before the first measurements are even made. This is due to the fact
that the IR sensor must cool down before you can resume your measurements.

8. Battery Replacement

The low-battery indicator will appear in the lower left-hand corner of the LCD display when the battery is running low
and needs to be replaced.
Open the battery compartment, remove the old battery, replace it with a new one and close the battery compartment.

9. Practical Tips

• Infrared thermometers measure an object's surface temperature. The optical part of the device gathers data on
the target object through the IR sensor. The electronics translate the information into a temperature reading that is
displayed on the LCD. The laser is used for aiming purposes only.
• Make sure that the target is larger than the diameter of the beam. The smaller the target object, the closer you
should be to it. The target should be at least twice as large as the beam if accuracy is critical.
• The size of the area measured by the beam becomes larger as your distance to the target object increases.
• Avoid temperature measurements on shiny or polished metal surfaces. The beam might reflect into your eyes.
• The device cannot measure through transparent surfaces such as glass. It will measure the surface temperature
of the glass instead.
• Steam, smoke, etc... can cause inaccurate readings by interfering with the optics.
• 90% of all organic materials and painted or oxidised surfaces have an emissivity of 0.95 (factory setting in this
device). Shiny or polished surfaces will generate inaccurate readings. Cover the surface in question with black
paint or masking tape to compensate for the measurement error. Allow some time for the tape to reach the same
temperature as the material underneath.

10. Emissivity Values

Substance
Asphalt
Concrete
Cement
Sand
Earth
Water
Ice
Snow
Glass
Ceramics
Marble
Plaster
Mortar
Brick
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
DVM8810
Thermal Emissivity
0.90 - 0.98
0.94
0.96
0.90
0.92 - 0.96
0.92 - 0.96
0.96 - 0.98
0.83
0.90 - 0.95
0.90 - 0.94
0.94
0.80 - 0.90
0.89 - 0.91
0.93 - 0.96
Substance
Cloth (black)
Human Skin
Lather
Charcoal (powder)
Lacquer
Lacquer (matt)
Rubber (black)
Plastic
Timber
Paper
Chromium Oxides
Copper Oxides
Iron Oxides
Textiles
5
Thermal Emissivity
0.98
0.98
0.75 - 0.80
0.96
0.80 - 0.95
0.97
0.94
0.85 - 0.95
0.90
0.70 - 0.94
0.81
0.78
0.78 - 0.82
0.90
VELLEMAN