Troubleshooting Guide; Possible Cause - Blade Mach 25 FPV Racer Bedienungsanleitung

Troubleshooting Guide

Problem
Quadcopter control response is
inconsistent or requires extra
trim to neutralize movement
Quadcopter will not respond
to throttle
Quadcopter does not function
and smells burnt after
connecting the flight battery
Quadcopter has reduced flight
time or is underpowered
Difficulty binding
Difficulty connecting
(after binding)
Crashes immediately upon
lift-off
EN

Possible Cause

Quadcopter not initialized on a level
surface
Battery not correctly placed in
battery slot
Throttle too high and/or throttle trim
is too high
Quadcopter moved during initialization
Throttle channel is reversed
Flight battery connected with the
wrong polarity
Flight battery charge is low
Inadequate power to flight battery
charger
Flight battery is damaged
Flight conditions might be too cold
Transmitter too near aircraft during
binding process
Bind switch or button was not held
while transmitter was powered on
Quadcopter or transmitter is too close
to large metal object, wireless source
or another transmitter
Less than a 5-second wait between
first powering on the transmitter and
connecting the flight battery to the
quadcopter
The quadcopter is bound to a different
model memory (ModelMatch™ trans-
mitters only)
Flight battery or transmitter battery
charge is too low
Quadcopter or transmitter is too close
to large metal object, wireless source
or another transmitter
Propellers in wrong locations or
incorrect flight mode selected
Aileron, elevator or rudder are reversed
in the transmitter
10
Solution
Disconnect the flight battery, center the
control trim and re-initialize the quadcopter
Adjust battery position so quadcopter bal-
ances in the center of the frame
Reset controls with the throttle stick
and throttle trim at the lowest setting
Disconnect the flight battery and re-
initialize the quadcopter while keeping the
quadcopter from moving
Disconnect flight battery, reverse the
throttle channel on the transmitter,
recconnect flight battery
Replace the 4-in-1 board. Connect the
flight battery noting proper polarity
Completely recharge the flight battery
Use a different power source for the
charger
Replace the flight battery and follow the
flight battery instructions
Make sure the battery is warm (room tem-
perature) before use
Power off the transmitter. Move the trans-
mitter a larger distance from the aircraft.
Disconnect and reconnect the flight bat-
tery to the Quadcopter. Follow the binding
instructions
Power off transmitter and repeat bind
process
Move quadcopter and transmitter to an-
other location and attempt binding again
Leave the transmitter powered on. Discon-
nect and reconnect the flight battery to the
quadcopter
Select the correct model memory on the
transmitter. Disconnect and reconnect the
flight battery to the quadcopter
Replace or recharge batteries
Move quadcopter and transmitter to anoth-
er location and attempt connecting again
Ensure propeller direction and motor
direction are correct
Ensure aileron, elevator or rudder are not
reversed