Operation - Ferm SSM1007 Übersetzung Der Originalbetriebsanleitung

No-load speed
Blade length
Max. Cutting depth at 90°
Max. Cutting depth at 45°
Max. Cutting length/working depth 406mm
Weight
Sound pressure (L )
PA
Acoustic power (L )
WA
Description
The numbers in the following text refer to the
pictures on page 2 ­ 4.
Fig. A
1. On/off switch
2. Angle adjustment knob
3. Speed adjustment knob
4. Saw blade holder
5. Protective cover
6. Spanner
7. Dust blow pipe
8. Workpiece holder
9. Table inlay
10. Foot pedal switch
11. Connection vacuum cleaner
12. Locking knob
13. Operation switch
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Install of a stationary machine
Fig. B
This machine is a stationary machine and for
safety reasons we recommend the machine
to be firmly installed and not used for mobile
applications.
The machine can be mounted to a workbench as
shown on Fig. B. The machine must be mounted
on the same 4 points that the rubber feet are
assembled. Each of the 4 points must be secured
with a bolt, washer and nut. The necessary tools
and small parts for assembling the saw on a
workbench are not supplied with the saw.
6
400 - 1600 min
-1 Installing the protective cover
Fig. C
125mm
Before commissioning the machine, the protective
50mm
cover (5) must be installed.
23mm • Mount the protective cover on the metal part
• Insert the screw as shown on Fig. C
10.4kg
• Screw the nut tightly.
78 dB(A) K=3dB
91 dB(A) K=3dB

4. OPERATION

Switching on/off
Fig. A1
Place the machine onto a flat and solid surface.
Place the Foot pedal switch (10) on the ground.
The machine can be switched on/off when
the pedal is actuated. A foot pedal switch for
switching on/off is practical, especially for internal
cuttings, since your hands are kept free and you
can fully concentrate on the work piece under the
scroll saw. The foot pedal switch cannot influence
the speed (see below Speed Adjustment).
Continuous operating mode
• Use the Operation switch (13) to choose for 'I'
• Connect the scroll saw to the mains.
• Start the machine by pushing the green ON­
Push the red OFF­switch (1) to turn the machine off.
Foot pedal operating mode
• Use the Operation switch (13) to choose for 'II'
• Connect the scroll saw to the mains.
• Push the green ON­switch (1).
• Start the machine by pushing the Foot pedal
as shown on Fig. C
Always observe the safety instructions
and obey the relevant regulations.
Beware of unintentional actuation of the
foot pedal switch.
Caution! Always choose the preferred
operation mode with the Operation
switch (13) before using the machine.
The machine will not start in 'O' mode.
continuous operation.
switch (1).
foot pedal operation.
switch (10) with your foot.