Tascam CD-A700 Bedienungsanleitung Seite 5

Voltage Conversion
(For general export models)
Be sure to remove the power cord from
the AC outlet before repositioning the
voltage converter switch.
1. Locate the voltage selector on the rear
panel.
2. Using a flat-bladed screwdriver, set to
the appropriate 230 V or 120 V position
according to your area.
Connections
O Before
connection, turn
components and pay special attention
to left (L) and right (R) channel
indications.
O Read the owner's manual of each
component you intend to use with this
unit.
∑ Signal cords
LINE INPUT/OUTPUT terminals
(Balanced/Unbalanced)
Use these terminals to connect the deck to
a mixer, cassette tape recorder or other
components.
O LINE OUTPUT terminals output the
compact disc or cassette deck tape
signal. When both compact disc and
tape are played back, the tape sound
has priority.
CD LINE OUTPUT terminals
(Balanced/Unbalanced)
Use these terminals to connect the deck to
the CD, DAT or AUX terminals of the stereo
amplifier.
O CD LINE OUTPUT terminals always
output the disc signal.
DIGITAL OUTPUT
This RCA connector outputs digital audio
data in SPDIF format.
Caution:
If the CD player interferes with the tuner,
TV reciever, etc., allow a reasonable
distance between them.
Rack Mounting
Install this deck with the provided mounting
screw kit as illustrated.
off all CONTROL I/O (Parallel port)
This 15-pin "D"-sub connector is used for
connection to
controller.
The pinouts of this connector are given
below.
Pin No. Component & Signal
1 CASSETTE
2 CASSETTE
3 CASSETTE
4 CD
5 CD
6 CD
7 CD
8 COMMON Ground
9 CASSETTE
10 CASSETTE
11 CASSETTE
12 CASSETTE
13 CD
14 CD
15 CD
∑ Power cord
Be sure to connect the power cord to an
AC outlet which supplies the correct
voltage.
a suitably-equipped
Direction
READY IN
REVERSE PLAY IN
FORWARD PLAY IN
REW IN
F. FWD IN
STOP IN
READY IN
—
STOP IN
F. FWD IN
REW IN
PLAY TALLY OUT
PLAY TALLY OUT
FADER
IN
START/READY
EVENT START IN
_ 5 _
Function
External command reception; active
when low (at ground potential for
30 ms or more)
—
External command reception; active
when low (at ground potential for
30 ms or more)
Transmit transport status indication
signals in open collector (maximum
allowable voltage 15 V and
maximum allowable current 80 mA)
Active when low (at ground potential
for 500 ms when ON/OFF)
Active when low (at ground
potential for 100 ms)
∑ Headphones
When using headphones, connect the
headphone plug into the PHONES jack.
O Adjust the level of the signals output
from the phones jack.