How To Read Control Box And Shear Lamps - Max Europe PASJ301/40A(CE) Betriebsanleitung

8. HOW TO READ CONTROL BOX AND SHEAR LAMPS

[LAMP ON THE CONTROL BOX]
Normal state (Lamp is green)
State of lamp
: Lit up
: Blinking
: OFF
Battery charge level is
Contents of display
full
Use the machine.
Remedy
If the battery charge level is low, the machine may not be able to cut twigs.
If an error or problem occurs (Lamp is red)
State of lamp
: Lit up
: Blinking
: OFF
Contents of dis- Motor temperature is
play high
Stop using the ma-
chine, wait until the
motor cools down,
Remedy then start the opera-
tion again.
[LAMP ON THE SHEARS]
Normal state (Lamp is green)
Power is supplied (Green)
Normal (Green)
Battery charge level is
medium
Error (Blinking red)
Blades were locked during
cutting action
Release the trigger and
switch lever. If the twig is
still caught in the blades,
open the blades, taking
care not to swing the ma-
chine laterally.
No power is supplied, Lamp off
27
Battery charge level is
low
No power is supplied to
the machine
Turn off the power, and
turn it on again after con-
firming the connection of
the connecting cable ter-
minals. If the display does
not disappear, the ma-
chine has a problem.
Machine stops
(Green)
Battery pack charge lev-
el is low
Charge the battery.
Problem
(Light up red)
Circuit trouble
If the red lamp lights up
(remains on), turn the
power on again. If the red
lamp still lights up after
that, stop using the ma-
chine and consult your
dealer.