Charging Method - Max Europe PASJ301/40A(CE) Betriebsanleitung

4. CHARGING METHOD

WARNING
 Charge at the specified voltage.
Be sure to charge using a AC220V - 240V
wall socket. Charging with a other voltage
other than that specified cannot only cause
problems but is also dangerous.
 Never charge with an engine generator
or a DC power supply.
This can not only cause a problem but also
can also result in abnormal heating and
fire.
 Use a standard wall socket.
The charger must be securely plugged into
a wall socket. The power plug must not be
loose or be able to come out easily. Use of
a wall socket that does not allow the power
plug to be inserted securely may result in
an accident caused by overheating. If that
is a possibility, use another wall socket.
 Keep the pack cap on the battery pack
whenever it is not being used.
 Initial state of battery pack
The battery pack is not fully charged when
you purchase it. Correctly charge the bat-
tery pack using the charger before use.
WARNING
 In its initial state, the battery pack, al-
though not fully charged, can be used to
operate the machine when it is attached.
Be careful not to operate the trigger
switch inadvertently.
 When installing or removing the battery
pack in the control box, check that the
power switch of the control box is
turned off.
1 (Fig. F) Remove the pack cap, which cov-
ers the battery pack terminal area, used
to prevent short circuiting.
(Fig. G) When the battery pack is used once
and installed in the control box, remove the
pack from the machine first.
(See P 20, How to remove the battery pack.)
2 (Fig. H) Plug the charger power cord into
a AC220V - 240V wall socket.
The red LED lamp blinks and a pip sounds
twice to indicate that the power is on.
3 Charge the battery pack.
(1) (Fig. I) Slide the battery pack firmly until it
reaches the end of the battery pack installa-
tion port of the charger.
(2) (Fig. J) If the battery pack is connected to the
charger, charging starts automatically.
The red LED lamp lights up and a pip sounds
once to indicate that the battery is being
charged.
(3) When the battery pack has been rapid-
charged, the red indicator LED lamp will start
to blink green.
(Fig. K) When the green LED lamp blinks, a
beep will sound for approximately two sec-
onds. At this point, the battery has been re-
charged to approximately 90% capacity.
The rapid charging process takes approxi-
mately 50 minutes. (However, the recharg-
ing time and capacity will charge slightly
depending on the ambient temperature and
power voltage)
(Fig. L) You can use the battery pack when
rapid charging is complete. However, if you
leave the battery pack on the charger, charg-
ing will continue. When the battery is fully
charged (to 100% capacity), the green LED
lamp lights up (and a beep will sound for ap-
proximately two seconds).
4 (Fig. M) After you have charged the bat-
tery pack, remove it from the charger.
5 (Fig. N) Unplug the charger power cord
from the wall socket.
17