Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. PREPARATION FOR USE
1. Installing or removing the battery
pack
WARNING
When installing or removing the battery
pack in the control box, check that the
power switch of the control box is
turned off.
Make sure that the battery pack is correct-
ly installed in the control box before use.
An incorrectly installed battery pack may
fall off during operation, which may result in
personal injury.
(Fig. O) To install the battery pack, first align the
slot on the battery pack with the slot on the con-
trol box, then slide it in the direction of the arrow
until it clicks securely in place.
(Fig. P) To remove the battery pack from the
control box, press the latches at both sides and
slide the pack straight forward in the direction of
the arrow, while holding the hollow part on the
control box side with your other hand.
2. Preparation for use
1 (Fig.Q) Put your arms through the shoul-
der straps.
2 (Fig.R) Secure the waist belt, pull it to the
right and left to adjust the length so that
it fits properly.
3 (Fig.S) Adjust the length of the shoulder
straps so that it fits properly.
4 (Fig.T) Secure the chest belt and adjust
the length so that it fits properly.
5 After adjusting the shoulder straps and
belts, remove the waist belt and chest
belt, and set the battery holder down.
6 (Fig.U) Install the battery pack in the con-
trol box.
3. Installation method
1 (Fig. V) Unzip the battery holder and pass
one of the cable connector through a hole
in the battery holder. There are holes on
both sides and be sure to pass the con-
nector through the hole on your domi-
nant arm side.
2 (Fig. W) Store the control box containing
the battery pack into the battery holder so
that the terminal of the control box is on
the same side as your dominant hand.
Store the terminal of the control box facing
upward.
3 (Fig.X) Firmly fasten the control box stor-
age section of the battery holder using
the hook and loop fastener.
4 (Fig.Y) Connect the connecting cable to
the control box terminals and tighten the
screws of the terminals on the connect-
ing cable side.
You can connect either terminal at the right
and left ends of the connecting cable.
The terminal on the control box side has
a projection while the connecting cable
side is a hollow. Connect the cable so
that they will fit with each other.
For a simplified control box chart, see p 28.
5 Zip up the battery holder.
6 (Fig. Z) Pass the bottom of the connect-
ing cable terminal at the unconnected
end through the cable guide of the bat-
tery holder, taking care not to touch the
inside of the terminal.
7 (Fig.AA) Putting on the battery holder
Hold the bottom of the connecting cable ter-
minal at the unconnected end with the hand
that you will use to hold the shears, be sure
not to touch the inside of the terminal. Carry
the battery holder on your back as you would
carry a back pack.
(Fig.AB) Insert the waist belt through the hol-
ster, strap the holster and battery holder, and
buckle the waist belt, shoulder straps and
chest belt.
If you use a purchased waist bag in addition
to the battery holder, adjust the bottom of the
battery holder to the top of the waist bag belt
so that you can easily put on and take off the
battery holder.
Make sure that the connecting cable
does not get between your body and
the shoulder band of the battery pack.
8 (Fig.AC) Connecting the machine and
connecting cable
Insert the connecting cable terminal into the
machine terminal and turn it to the right to
connect it securely.
Similarly to when connecting the con-
trol box, match the hollow and projec-
tion of the connecting cable and
machine.
20
Werbung
Kapitel
Inhaltsverzeichnis
