Maintenance Procedure - Max Europe PASJ301/40A(CE) Betriebsanleitung

7. MAINTENANCE PROCEDURE

WARNING
 When inspecting or servicing, be sure to
turn off the switch of the control box
and disconnect the connecting cable
from the machine.
If you inspect or service the machine with
the connecting cable connected, an unex-
pected accident may occur.
1 How to maintain blades
(Fig.BI, BJ) After working, remove dirt from
both sides of the blades using a hard brush
and wipe them with wet cloth for storage.
If the blades are not maintained, the friction
of the blades will increase and the usage
time after one charge is shortened.
The lives of the blades will also be short-
ened.
2 How to sharpen blades
(Fig.BK, BL) How to sharpen upper blade
Match the flat side of the grindstone to the
angle of the blade edge, press it in the direc-
tion of the arrow and sharpen the entire
blade edge.
CAUTION
 (Fig.BM) Do not sharpen the lower
blade.
CAUTION
 Do not sharpen the reverse side of the
blade.
3 Cautions when not using the machine for
long periods
When not using the machine for long peri-
ods, remove the battery pack from the con-
trol box and charge it fully. Fit the pack cap
to the battery pack, and store the machine in
a dry location where it will not be affected by
high temperatures.
The battery pack will discharge even if it is
not used, although at a very slow rate. If the
battery is kept at a low charge level for a long
period, it will become unusable.
Even if you do not use the machine for a long
period, charge the battery once every six
months or so.
4 Never modify or carry out repair work on
this machine
If this machine is modified, it will not operate
optimally and may become a safety risk.
Therefore, do not modify it under any circum-
stances.
5 Periodic inspection of the machine
To maintain the machine's performance, car-
ry out cleaning and inspection.
26