Max Europe PASJ301/40A(CE) Betriebsanleitung Seite 25

(1) How to remove blades
1 (Fig.AP) Put the shears on a worktable
with the lower blade turned upside, loos-
en bolt with the attached special tool, and
remove the bolt and washer.
2 (Fig.AQ) Turn the blade holder with the
special tool in the direction of the arrow
and remove the blade holder.
3 (Fig.AR) Turn over the body, loosen the
bolt, and then remove the bolt.
4 (Fig.AS) Remove the plastic cover.
5 (Fig.AT) Do not remove the blade shaft.
To replace the upper blade, remove the
hex socket button head screw "a" with
the attached hex wrench, and to replace
the lower blade, remove the hex button
head screw "b".
WARNING
 If the blade shaft is removed first, turn-
ing a hex socket button head screw will
turn a blade, which brings danger.
6 (Fig.AU) Pull out the link pin.
7 (Fig.AV) Remove the shaft.
8 (Fig.AW) Pull out the blades to be re-
placed.
 Be sure to wear gloves. Touching the
upper blade with bare hands may cause
injury.
(2) How to attach blades
1 (Fig.AX) Apply the attached grease to the
upper and lower replacement blades.
2 (Fig.AY) Fit the link in the hole in the
blade.
3 (Fig.AZ) Apply the attached grease all
around the shaft.
4 (Fig.BA, BF) Insert the blade shaft into
the shaft hole with its flat face matched
with the hole.
 If it is difficult to insert the shaft, swing
the lower blade in both vertical and lat-
eral directions.
5 (Fig.BC) Insert the link pin into the hole
and align the hole in the link pin and the
hole in the blade for the screw.
6 (Fig.BB) Check that the shaft is inserted
and then tighten the hex socket button
head screw.
7 (Fig.BD) Attach the plastic cover.
 When assembling, when attaching the
plastic cover, forcibly tightening with
the convex portion of the shaft while
not securely fitted in the hole in the
plastic cover may damage the plastic
cover.
8 (Fig.BE) Tighten the bolt.
9 (Fig.BH) Turn over the body and turn the
blade holder in the direction of the arrow
with the special tool to tighten it.
WARNING
 Tighten it with the tool until it cannot be
turned any more.
0 (Fig.BG) Attach the washer and be sure to
tighten the bolt using the special tool.
After carrying out the above process, connect
the machine to the control box and check its op-
eration.
If the upper and lower blades are operating cor-
rectly, the replacement work is completed.
If the blades do not operate correctly, remove
and install them again according to the proce-
dure in "HOW TO REPLACE BLADES" (P 24). If
the machine still does not operate correctly, re-
turn it to your dealer for inspection or repair.
25