How To Store The Shears In The Hol - Max Europe PASJ301/40A(CE) Betriebsanleitung

6. How to store the shears in the hol-

ster
(Fig. AK, AL) Turn off the power switch of the
control box while pulling the trigger (with the
blades closed)
 While the blades are closed, check that the
lamp of the shears is turned off.
WARNING
 When storing the shears in the holster,
be sure to close its blades.
If the machine is stored while its blades are
open, you may be injured and the holster
may be broken.
 If the trigger lock lever is locked with the
trigger pulled (with the blades closed), the
blades are kept closed even if the trigger is
released after that.
To open the blades again, release the trig-
ger lock lever while depressing the trigger
and switch lever.
 Pressing the standby mode switch once
with the trigger pulled sets the machine to
the standby mode and the blades remains
closed even if you release the trigger. To
recover the shears, press the standby
mode switch once with the trigger held to
exit the standby mode.
7. Pruning method
WARNING
 Use safety glasses.
Wear safety glasses when using the ma-
chine. Otherwise you run the risk of eye
damage due to flying chips.
(Fig. AM) When pruning, cut twigs one by one
between the upper and lower blades.
(This machine can cut twigs with a diameter of
up to approximately 30 mm. When the opening
angle of the blades is changed, the diameter can
be up to about 20 mm.)
 If the battery charge level is low, the ma-
chine may not be able to cut twigs.
 The machine may not be able to cut twigs,
depending on the dryness of the wood or
other factors.
When stopping work, lock the trigger lock lever
with the blades closed or turn off the power
switch of the control box, and then store the
shears in the holster.
 If the machine is not used for five minutes,
it is set in the standby mode automatically.
When starting work again, release the trig-
ger lock lever. Then, pull the trigger and
press the standby mode switch, and you
can restart pruning work. After the buzzer
sounds, you can restart pruning work.
 If the machine is not used for 60 minutes,
the power is turned off automatically.
 When starting the work again, turn the
switch off, and then turn it on again. Then,
pull the trigger and press the standby mode
switch, and you can restart pruning work.
After the buzzer sounds, you can restart
pruning work.
When you have finished pruning, turn off the
power of the control box with the blades closed,
disconnect the connecting cable, remove the
battery pack from the control box, fit the pack cap
to the battery pack, and store the machine in a
dry location that is not affected by high tempera-
ture and that is away from children.
23