Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. PRUNING SHEARS SAFE-
TY WARNINGS
1. BE SURE TO KEEP HANDS AWAY FROM
THE TRIGGER SWITCH AND DETACH
THE BATTERY PACK WHEN REPLACING
OR ADJUSTING THE BLADES, WHEN
ABNORMALITIES OCCUR, AND WHEN
THE EQUIPMENT IS NOT BEING USED
Leaving the Battery pack installed in these
situations may cause breakdowns or dam-
age.
2. HOLD TOOL BY INSULATED GRIPS
WHEN PERFORMING AN OPERATION,
BECAUSE THE TOOL'S BLADES MAY
CONTACT HIDDEN "LIVE" WIRE
Contacting with a "live" wire may make ex-
posed metal parts of the tool "electrified" and
shock the operator. Failure to do so may re-
sult in serious injury.
3. DO NOT POINT THE TOOL AT ANYONE
Personal injury may result if the tool catches
an operator or anyone working near him/her.
While working with the tool, be extremely
careful not to bring hands, legs, and other
body parts near the Blades of the tool.
4. NEVER MODIFY THE TOOL
Modifying the tool will impair performance
and operating safety. Any modification may
lead to serious injury and void the tool war-
ranty.
5. THIS APPLIANCE IS NOT INTENDED FOR
USE BY PERSONS (INCLUDING CHIL-
DREN) WITH REDUCED PHYSICAL, SEN-
SORY OR MENTAL CAPABILITIES, OR
LACK OF EXPERIENCE AND KNOWL-
EDGE,UNLESS THEY HAVE BEEN GIVEN
SUPERVISION OR INSTRUCTION CON-
CERNING USE OF THE APPLIANCE BY A
PERSON RESPONSIBLE FOR THEIR
SAFETY.
Children should be supervised to ensure that
they do not play with the appliance.
6. MINORS SHOULD NEVER BE ALLOWED
TO OPERATE THE TOOL; IT SHOULD
NEVER BE LEFT UNATTENDED AND
WHEN NOT IN USE SHOULD BE STORED
IN A LOCKED PLACE OUT OF THE
REACH OF CHILDREN.
7. DON'T USE THE MACHINE OR PERFORM
BATTERY CHARGING OPERATIONS IN
THE RAIN.
8. DON'T LEAVE THE MACHINE IN RAIN OR
WET LOCATIONS.
9. KEEP BYSTANDERS WELL AWAY FROM
YOUR WORK AREA.
10. BE CAREFUL NOT TO CATCH FOREIGN
MATTER BETWEEN THE BLADES.
If the blades are jammed with foreign matter,
immediately switch off the machine.
Then remove the foreign matter from the
blades.
11. TAKE CARE, AVOID CUTTING ELECTRI-
CAL WIRES THAT MAY BE HIDDEN.
12. KEEP HANDS AWAY FROM MOVING
PARTS
13. KEEP YOUR FREE HAND AWAY FROM
THE CUTTING AREA.
Never touch the blades. They are very sharp
and you may cut yourself.
14. BE VIGILANT WHEN OPERATING TO EN-
SURE THAT THE FINGERS ON THE
HAND USED TO HOLD OR MOVE TWIGS
TO BE PRUNED ARE NOT EXPOSED TO
THE CUTTING BLADE.
15. USE ONLY THE AUTHORIZED BATTERY
PACK
Use only MAX JPL92540A battery pack. If
the tool is connected to a power supply other
than the authorized pack, such as a re-
chargeable battery, a dry cell, or a storage
battery for use in automobiles, the tool may
be damaged, break down, overheat, or even
catch on fire. Do not connect this tool to any
power supply except the MAX JPL92540A
battery pack.
16. TO ENSURE MAXIMUM PERFORMANCE,
FULLY CHARGE THE BATTERY BEFORE
USE
A new battery pack or one not used for ex-
tended periods may have self-discharged
and thus may need recharging to restore it to
a fully charged condition. Before operating
the tool, make sure to charge the Battery
pack with the designated MAX Battery
charger JC925.
12
Werbung
Kapitel
Inhaltsverzeichnis
