Max Europe PASJ301/40A(CE) Betriebsanleitung Seite 22

5. How to switch between "thin twig
mode" and "thick twig mode"
What is the thin twig mode?
 In the thick twig mode, the shears accepts
twigs of up to 30 mm in diameter between the
blades, and in the thin twig mode, they accepts
twigs up to 20 mm in diameter.
 It is suitable for cutting in a narrow place with
tangled twigs or cutting thin twigs continuously.
WARNING
 In the middle of the following switch-
ing procedure, the blades make a mo-
tion.
Be careful of motion of the blades.
Switching procedure (after exiting the standby
mode)
1. (Fig.AJ) Push the change lever in the direction
of the arrow.
2. Pull the trigger once as in cutting twigs and
then release the trigger. That changes the
mode.
■ Caution for the above operation
 Be careful because the blades will close.
 One long beep (Piii...) indicates a change to
the thin twig mode and two short beeps (Pi, pi)
indicate a change to the thick twig mode.
 If no beep sounds, release the finger from the
trigger and repeat the steps from 1.
 If the mode cannot be changed proper-
ly,
■ Did you push the change lever
enough?
■ After the beep, did you pull the trigger
once? After you pull the trigger, the
blades are closed once and then the
angle changes.
Following the procedure on the previous page
switches the angle of the blades between the
"thin twig mode" and the "thick twig mode".
Every time you complete the procedure, the "thin
twig mode" changes to the "thick twig mode" and
vice-versa.
 However, regardless of the mode (thin twig
mode or thick twig mode), restarting after
power-off (including auto power-off) sets
the shears to the thick twig mode and re-
turning from standby sets the shears to the
previous mode.
 To keep the thick twig mode
a) Quickly hold the trigger 5 times. (in the
standby mode)
b) Disconnect the connection cable from the
shears.
c) When a long beep (Piii...) sounds from the
control box, turn the power off.
d) Follow the procedure from P20 to P21.
 After completing steps from a) to d), the
procedure of switching the angle does
not change the mode to the thin twig
mode and the shears remains in the
thick twig mode.
 To restore the initial state, follow steps a)
to d) in the same way.
22