How To Replace Blades - Max Europe PASJ301/40A(CE) Betriebsanleitung

MOTOR PROTECTION FUNCTION
This machine has a circuit that stops the ma-
chine when the motor becomes hot.
If the motor stops, stop using the machine, turn
off the power switch, wait until the motor cools
down, and then start the work again.
 Notification that the machine stopped be-
cause of motor high temperature
The buzzer sounds and the two at both ends of
the three lamps on the control box blink in red
and the center one goes off.
CAUTION
 Avoid using the machine in a way in
which the motor protection function op-
erates on a frequent basis.
This can cause the motor to heat up or ex-
perience other problem.
1. If a twig is caught in blades
If a twig is caught in the blades (cannot be cut by
the cutting action), release the trigger. Releasing
the trigger moves the blades in the opening di-
rection.
If the twig is still caught in the blades after releas-
ing the trigger, do not move the machine to the
sides but move it slowly in up and down with the
trigger released to free the twig from the blades.
WARNING
 If the blades break and scatter, workers
may sustain injuries that lead to loss of
eyesight or other serious injuries.
(Fig.AN) Do not move the blades in a later-
al direction since the trigger may break and
the blades may be crushed.
a: Correct usage method
b: Lateral movement during the cutting ac-
tion that can break the blades

6. HOW TO REPLACE BLADES

WARNING
 Before replacing blades, turn off the
power switch of the control box with the
blades closed and disconnect the con-
nection cable from both the control box
and the body.
 When replacing the blades, be sure to
wear gloves.
 Perform the work on a stable bench.
[STRUCTURE AROUND SHAFT]
How to replace blades
WARNING
 When the cover is opened with blades
open, close the cover and start over the
procedure again.
 When replacing blades, be sure to wear
gloves.
 Work on a stable worktable.
 Do not operate the machine without the
cover.
24