Switch Operation - Max Europe PASJ301/40A(CE) Betriebsanleitung

(Fig.AD) Before putting the shears in the battery
holder for carrying, be sure to disconnect the ca-
ble, put the shears in the holster, and fasten the
grip with the hook and loop fastener.
WARNING
 Be sure to put the shears in the holster
before putting it in the battery holder.
If the shears are not in the holster, the
blades may break through the battery hold-
er and cause an injury.
CAUTION
 This product is made for the battery
holder of the rechargeable pruning
shears. Do not use it for any other pur-
pose.
 Do not expose it to water because it is
not waterproof.
 Do not put a container with liquid such
as a drink inside the battery holder. This
may get the control box or the battery
wet and cause a fault.
 Keep it away from fire.
 Do not keep it near an organic solvent
such as thinner and benzine.
 After working, remove batteries from
the control box.
 Do not put an article other than the re-
chargeable pruning shears in the bat-
tery holder.

4. Switch operation

CAUTION
Before connecting the control box
 Check that you cannot pull the trigger
unless you depress the switch lever.
 Check that the trigger returns when you
depress the switch lever and pull and re-
lease the trigger.
If the switch lever or trigger does not oper-
ate correctly, it could result in an accident.
1 (Fig.AE) Turn on the power switch of the
control box.
 When the switch is turned on
The green LED lamp of the shears lights
up.
Check that the machine is standing by and
that the green LED lamp lights up.
At this time, one to three of the green LED
lamps on the top of the control box light up.
 The three green LED lamps indicate the
battery charge level. If all of the three
LED lamps are lit up, the battery is
charged sufficiently. If only one green
LED lamp is blinking, charge the battery.
 The battery charge level shown on the
control box may differ from that on the
body.
 If the green LED lamp of the shears does
not light up,
the following causes are possible:
 The cable is not properly connected.
 The batteries are not surely set in the control
box.
 The remaining battery level is low.
 The batteries are defected.
2 (Fig.AF) Release the trigger lock lever of
the shears.
 When the blades are closed
While depressing the trigger push the trig-
ger lock lever in the direction of the arrow
to release the lock.
3 (Fig.AG) Exit the standby mode.
Press the standby mode switch with the trig-
ger pulled to open the blades.
4 (Fig.AH) If the trigger is pulled (
blades move in the closing directions. If
the trigger is not released, the blades
stop at the closed positions.
If the trigger is released (
moves in the direction of the opening and
stops at the fully open positions.
The blades open and close according to the
extent the trigger is pulled.
21
) the
), the blade