Velleman HAM06WS Bedienungsanleitung Seite 5

d. Activating the alarm system
There are two ways to activate the alarm system.
1. AWAY activation:
The system reacts to all connected and programmed sensors. The message "ARM st" will be displayed
and you will hear the vocal message "System armed". Activate the system by pressing the AWAY button.
2. HOME activation:
This mode will only secure programmed zones while other will not be covered by the system. This allows
the user to freely access some zones without triggering the alarm. The message "GUARD st" will be
displayed and the vocal message "System armed" will be heard. Activate the system by pressing the
HOME button.
REMARK: Sensors programmed for fire, gas or panic detection (24h-function) will remain activated, even
when the system is in DISARM mode.
e. Entering the programming mode
To enter the programming mode, put the central unit in DISARM mode first and press the SET button. The
message "INPUT LEVEL" will be displayed. Enter the system code (6 characters), followed by a press of the
# button to confirm.
Example:
0
The programming menu will be displayed.
f. Overview of the programming menu and settings
Note: the programming menu is only available when the system is in disarm mode.
#
*
This is what the programming menu looks like:
1. Sys
2. Zone
3. Setup
4. Study
18.04.2017
0 0
1. Sys
3. Setup
Confirming button.
Return to the previous menu and quit the programming mode.
1. Level
2. Code
3. Report
4. Delay
01
⋅⋅⋅
(wired)
04
05
⋅⋅⋅
(wireless)
12
1. Alert
2. Home
3. Call
4. Del home
1. Remote
2. Arm zone
3. Del
HAM06WS
SET
Input
Level
0 0
2. Zone
4. Study
1. Sys Level
2. User Level
1. Arm report
2. No report
1. Instant
2. Delay (zone)
}
3.24 HR
4. Bypass
1. Tel
2. Dial
3. Vibrant ring
5
0 #
1. Smoke
2. Gas
3. Panic
1. Tele 1
2. Tele 2
3. Tele 3
4. Tele 4
©Velleman nv