Wiring Diagram; Normal Mode Visualization; Customization Of The Installation; Description Of The Buttons - Key Automation VIPER Anleitungen Und Hinweise Zu Installation Und Einsatz

EN

4.5 Wiring diagram

WARNING - Before making connections verify that the installation is not powered
Wiring diagram photocell, safety connection STOP and step/step command P/P
The emergency STOP contact must be connected between no. 2 and no. 3 (contact normally closed NC)
The step/step contact P/P must be connected between no. 2 and no. 1 (contact normally open NA)

4.6 Normal mode visualization

In "NORMAL MODE", when the installation is powered normally, the 2-digit LCD displays rotates and after 30 sec. will turn off
2
1
4.7 Customizing the installation
Programming
Preparation A. Gently move the door to activate the carriage so that the automation system can guide the door
B. Power on. The light will turn on, the unit provides a single audible signal and the display indicates"0" in cycles.
Attention: If programming is not complete, the settings will be cancelled automatically. If incorrect information has been pro-
grammed, power off and then power back on, referring to the following.

4.8 Setting of opening limit

Warning: the saved information has no effect if this procedure is used for setting the limit of closing
Press the key "P" for
5 seconds
Door opening
Door closing
20
Display
Limit switch
ENCODER
+24V
Photocell
-Shared
COM
5
3
4
The unit emits 1 beep and "1"
is displayed.
When the door opens and reaches
the ideal position, press the key "P"
to save the information.
TX
TX
1 2
24Vac/dc
- +

Description of the buttons

1 - P function button
2 - S memorization of remotes button
3 - + parameter increase button
4 - - parameters decrease button
5 - Display
Press "P", "1" flashes
RX
COMMON
RX
1 2 3 4
24Vac/dc
- +
NC
Press"+"
Or press "-"