Ace 2.0 App - BMW Advanced Car Eye 2.0 Bedienungsanleitung

If the ACE 2.0 is connected to the ACE 2.0 app
when you switch to parking mode, an image will
be saved from both the front and rear window
cameras in the "Car Location" menu point in the

ACE 2.0 app.

At the same time the position of the car will be
shown on a map (the smartphone must have a
GPS signal for this to work). The ACE 2.0 must
have a GPS signal when you switch to parking
mode, otherwise the last location of the car when
a GPS signal was available will be displayed.
This scenario may occur, for example, if you park
in an underground or multi-storey car park.
ACE 2.0 app
The ACE 2.0 app must not be used by
the driver whilst the engine is running or
whilst driving.
Connect your smartphone to the Wi-Fi hotspot
of the ACE 2.0 and start the ACE 2.0 app (see
section "Commissioning"). The main menu
appears. You can access the menu points by
tapping the icons.
The recording will be stopped temporarily
whilst you change the settings and play
the videos and images on the micro SD
card. Listen to the voice output from the
camera.
The following contains a summary of the ACE
2.0 app contents.
To enable the ACE 2.0 to be controlled using
the ACE 2.0 app even when the ignition is
not switched on, a timeframe of 3 minutes is
provided to establish the connection after the
engine is switched off. The connection will
remain active for as long as you interact with the
ACE 2.0 using the ACE 2.0 app.
41