Operation / Control - G-U ELTRAL KS 30/40 Solo Montage- Und Bedienungsanleitung

Assembly and operating instructions
ELTRAL KS 30/40 Solo
Chain drive

10 Operation / Control

LED indication (does not apply to SYNCHRO variant)
The LED indicates the drive's different modes of operation. It is located on the opposite side of
the connecting cable outlet.
Status of LED
Constantly lit
Off and flashing
Regular blinking
On and flashing
For reversing the running direction, the drive must be de-energized for at least 1 s.
Switch-off in closed position
Thanks to the integral load interruption, the drive switches off in closed position. Setting the
limit switch is therefore not required. When the end position is reached, the drive carries out a
reverse travel of approx. 1 mm. Thus relieving both gaskets and holding brackets.
Setting the travel
The factory setting of the travel is 400 mm; it can be changed via DIP switches at any time. The
DIP-switches lie detailed under the black screw cap on the upper side of the engine case. The
DIP switches 1 and 2 have to be set according to the following table.
In order to make a change effective, it is necessary to extend the chain a little bit and retract it
again.
After changing the travel, a test run should be carried out.
Setting the travel - version 230 V
Travel [mm]
400
300
200
100
Switch shown in
„ON" position
26
Meaning
Drive in operation
Drive has reached the limit stop in open position
Drive is stopped by the electronic load interruption / Overload
Version 24 V: malfunction ELTRAL VAN
Version 230 V: general error / malfunction
DIP-switch
1 2
ON ON
OFF ON
ON OFF
OFF OFF
Travel 400 mm
Travel 200 mm
Travel 300 mm
Travel 100 mm