Dimensioned Drawing; Installation Method; Preparing To Install - G-U ELTRAL KS 30/40 Solo Montage- Und Bedienungsanleitung

Assembly and operating instructions
ELTRAL KS 30/40 Solo
Chain drive

Dimensioned drawing

To determine the installation variant depending on the sash height, refer to the following table or
the charts in chapter „18 Application diagram" on page 33:
Min. sash high

Installation method

Tilt window inward frame mounting
Tilt window inward sash mounting
Top hung window outward frame mounting
Note!
º
6

Preparing to install

DANGER Incorrect use may cause injury to people and damage to property
Refer to the type label of the motor and the technical data in chapter
„5 Technical data for 1 motor" on page 21 to ensure that you have the
correct motor for your installation situation
Examine the delivered equipment immediately upon receipt and check it for transport
º œ
damage. Do not install the motor if it is damaged.
With tilt sashes, the clearance
between frame and sash profile
must be at least 1 mm in order
to provide for safe closing of the
Note! window.
If frame and sash profiles are
º
flush, or if the sash profile stands
back from the frame profile on
the interior side, it is necessary
to underlay the tilt sash bracket
accordingly.
22
Smaller sash heights
Please contact us if smaller sash heights are required.
Travel
100 mm 200 mm 300 mm 400 mm
250 mm 600 mm
200 mm 400 mm
150 mm 250 mm
1100 mm 1500 mm
650 mm 900 mm
350 mm 450 mm