Setting And Starting Aprogramme; Setting Mode - AEG GS60AIS221 Benutzerinformation

14
D
A
3
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting
mode to:
• Start a programme.
• Set the level of the water soft-
• Activate the rinse aid dispenser
Turn the programme knob until the pro-
gramme marker is aligned with a pro-
gramme on the control panel:
• If the programme duration flashes in
the display, the appliance is in setting
mode.
• If the programme duration in the dis-
play is not flashing, the appliance is not
in setting mode.
To put the appliance in setting mode,
press and hold Multitab and Delay until
the programme duration flashes in the
display and the phase indicators for the
programme come on.
A B
30
20
C
B D
0
2 0
+
ener.
when the Multitab function is
on.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
A
-
C
Starting a programme without
delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the programme knob until the
4. Press Start. The programme starts.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
CAUTION!
Use only detergents for dishwash-
ers.
programme marker is aligned with the
programme you want to set. Make
sure that the appliance is in setting
mode.
• The programme duration flashes in
the display.
• The phase indicators of the set pro-
gramme come on.
• The programme duration stops
flashing in the display and starts to
decrease with steps of 1 minute.
• Only the indicator of the phase in
operation stays on.
display shows the delay time you want
to set (from 1 to 19 hours).