Before Asking For Repair Work - Toshiba RBC-AX31UW-E Betriebsanleitung

Wireless Remote Controller Kit
12

BEFORE ASKING FOR REPAIR WORK

Check the following before asking for repair work.
Check again
Phenomenon
Operation does The air conditioner is not working or a power failure
not start even if has occurred.
the switch is
The power switch is not turned on.
turned on.
The air conditioner is in the ON timer operation.
The batteries of the remote controller have been
exhausted.
The LEDs on the signal receiving part are not in
normal state or operation mode is not correct.
"Auto" or "Heat" is displayed on the display though the air conditioner
is cool-only type.
Dual swing, cycle swing, individual louver position, or power-saving
cannot be set.
Contact the dealer from whom you purchased the air conditioner.
Phenomenon
The LEDs flash.
LEDs on the signal receiving part
LED color : Green
Check these items. If any of these problems still remains, stop the operation, turn off the power, and
then notifies the dealer from whom you purchased the air conditioner of the model name and details
of the error (including LED flashing state). Never repair any part by yourself as it is dangerous.
Possible cause
Communication error between signal receiving part and indoor unit
or address setup error when the wired remote controller is used
Communication error between indoor unit and outdoor unit
The protective device of the indoor unit is activated.
The protective device of the outdoor unit is activated.
Temperature sensor error
The compressor of the outdoor unit is protected.
The air conditioner is performing a test run. Set the test run switch
to OFF.
: OFF : Flashing (at intervals of 0.5 seconds)
: Green : Orange
– 14 –
Owner's Manual
Measures
Push on the remote controller again.
(See page 7)
Turn on the power switch if it is off.
(See page 7)
Cancel the timer operation.
(See page 8)
Replace the batteries.
(See page 10)
Change the operation mode.
(See page 4)
Change the slide switch setting of the
remote controller.(See page 10)
This type of remote controller cannot set
such functions.
Possible cause
EN
14-EN