Slide Switch; How To Insert Batteries - Toshiba RBC-AX31UW-E Betriebsanleitung

Wireless Remote Controller Kit
6

SLIDE SWITCH

• The settings of operation mode display and air direction display vary as follows depending
on the indoor unit in use.
• Use a fine-tipped tool to change the switch setting.
• Push the RESET button after the switch setting is changed.
1
Louver display switch
Louver display of the remote
controller
Slide switch position
* Set the slide switch to "S." Otherwise the air direction
adjustment and louver display are disabled.
2
Operation mode switch
Operation mode display of
the remote controller
Slide switch position
• Before using the air conditioner, check that the slide switch is set as shown in this table.
For details of slide switch setting, contact the dealer from whom you purchased the air
conditioner.
7

HOW TO INSERT BATTERIES

1
Slide and remove the cover downward while
holding both sides of the cover.
2
Insert two AAA alkaline batteries correctly matching
the (+) and (-) polarities with the indication.
3
Push the RESET button with a fine-tipped tool and
attach the cover.
• Replace batteries when the display on the remote controller has
become dim or when signals from the remote controller cannot
be received at the normal distance from the signal receiving
part. Alkaline batteries should be replaced once a year.
• Replace two batteries at the same time with new ones of the
same type.
• When you do not use the remote controller for a long time,
take out the batteries.
• Discard exhausted batteries at a designated place.
Heat pump
(With automatic
cooling/heating)
– 10 –
View with the cover removed
ACL
1
RESET button
Heat pump
(Without automatic
cooling/heating)
Owner's Manual
SENSOR
2
EN
Cool-only
RESET
button
Cover
10-EN