Toshiba RBC-AX31UW-E Betriebsanleitung Seite 5

Wireless Remote Controller Kit
Signal Receiving Part
• The signal receiving part is attached to the
indoor unit.
• Hereinafter, all remote controller button
names are indicated with respective
symbols displayed on the remote
controller.
Example: Start/Stop button →
1
2
3
1
Emergency operation button
(See page 13)
2
Signal receiver
Receives signals from the remote controller.
3
LEDs
Any of these LEDs flashes during an error
state.
When an LED flashes, see "BEFORE
ASKING FOR REPAIR WORK" on page 14.
4
Run LED (green)
Lights while the air conditioner is working.
5
Timer LED (green)
Lights while the timer is reserved.
6
Not Ready LED (orange)
• Lights in the heating mode at the beginning
of operation or during defrosting or when
the temperature controller is activated.
• Flashes during an error state.
The rear of signal receiving part
The following switches are provided on the
rear of the signal receiving part. For their
settings, contact the dealer from whom you
purchased the air conditioner.
• Header/follower switch
Normally, set this switch to "HEADER" to
use the remote controller as a header.
The remote controller can be used
together with the wired remote controller
4
(sold separately).
• Test run switch
5
Do not use this switch in normal operation,
6
but use for service.
• Address switches (See page 12)
Distinguish transmit signals and receive
signals.
• If "pi, pi" sound is heard with the Run
LED lighting and the Timer and Not
Ready LEDs flashing alternately while
the heat-pump type air conditioner is
used, desired operation mode is
disabled. The same is true if the AUTO
mode is selected in a model that is not
provided with the cool/heat auto
function.
• Even if you push
remote controller operation is disabled
by the central control or other means, "pi"
is heard 5 times and the button operation
is not accepted.
– 4 –
Owner's Manual
CAUTION
, or when
EN
4-EN