Operating-Presentation-Interfaces; Perating Principle - Cristec CPS3OEM Bedienungsanleitung

Our warranty does not cover:
1. Failure to abide by this manual
2. Any mechanical, electrical or electronic alterations to the appliance
3. Improper use
4. Presence of moisture
5. Failure to comply with AC power-supply tolerances (i.e. overvoltage)
6. Incorrect connections
7. Falls or impacts during transportation, installation or use
8. Repairs carried out by anyone unauthorized by CRISTEC
9. The maintenance in the energy conversion area made by a non-authorized person by
CRISTEC (breaking or unsticking of the seal sticker of warranty:"warranty")
10. Connection of any interface not supplied by CRISTEC
11. The cost of packaging and carriage
12. Apparent or latent damage sustained during shipment and/or handling (any such claims
should be sent to the haulier)
Our warranty on no account provides for any form of compensation. CRISTEC shall not be held liable for
damage incurred as a result of using the battery charger.
2. OPERATING–PRESENTATION–INTERFACES
2.1.
O

PERATING PRINCIPLE

The design of the battery chargers in the CPS3 range is based on a high-frequency split converter that
transforms the AC signal into regulated and filtered DC current. They can operate as a DC power supply.
Once the type of battery and type of charge has been selected, operation of the battery charger is entirely
automatic (Unless otherwise specified by the supplier or the manufacturer of the batteries). It can remain
connected to the batteries and does not need to be disconnected when starting up an engine (marine
application), because it is equipped with insulating diodes.
The appliance's output voltage is sufficient to recharge 1, 2 or separate 3 batteries (integrated charge
distributor, separation of batteries). All models feature an output suitable for recharging an engine battery
(BAT D output, marine application). The charger's maximum output is the rated current distributed to each
output according to the connected batteries banks.
Each output can deliver the rated current.
Not all the outputs have to be connected. However, if only one output is used, we recommend
interconnecting outputs BAT1, BAT2 and BAT D to one another (optional).
CPS3OEM-1M-2M-DEE 18