BWT Infinity A Einbau- Und Bedienungsanleitung Seite 17

Star Star tup tup
Star tup Star Star tup tup
Check that the filter and flushing water pipe have
been properly installed.
3 3 3 3 3
Slowly open the stop valves up- and downstream
of the filter. Deaerate the pipework at the next bleed
point downstream of the filter, and drain water briefly.
Check the seals of the installation and filter for
leaks.
24 V 24 V
24 V 24 V 24 V
Insert the cable plug connector of the transformer
into the socket (24V
Plug in transformer with plug (3 3 3 3 3 ). The first back-
washing cycle is performed automatically (during
backwashing the illuminated segments on the dis-
play turn).
The factory setting
Infinity A only Infinity A only Infinity A only Infinity A only Infinity A only
The required backwash interval must be set on the
filter.
Press Set Set Set Set to set the interval
Set
Set Set Set
Set Set
Set Set
Press Set Set for 5 sec. Set
Display 7 d
Pressing the Set
of h h h h h (hours) or d d d d d (days).
The hours h h h h h run from 1 1 1 1 1 - 24
from 2 2 2 2 2 - 56
Press the Set
set.
The value is saved 10 seconds after the last input.
The display dots go out. The unit backwashes.
The filter is ready for use.
24V 24V). 24V 24V
(7 days) appears.
7 8
7 d 7 d 7 d 7 d
Display dots flash;
device is in programming mode
Set Set Set key again steps up the number Set
24 24, followed by days d d d d d 24
24
56 56 56, followed by the hours again etc.
56
Set Set Set Set key until the desired value has been
GB GB GB
GB GB
1 7 1 7 1 7 1 7 1 7