Problems And Solutions; In Case Of Problems - switel DFT 8171 Bedienungsanleitung

13 In Case of Problems

Service−Hotline
Should problems arise with the telephone, please refer to the following in-
formation first. In the case of technical problems, you can contact our hot-
line service, Tel. 0900 00 1675 within Switzerland (cost via Swisscom at
time of going to print: CHF 2.00/min). In the case of claims under the terms
of guarantee, contact your sales outlet. There is a 2 year period of guaran-
tee.

Problems and solutions

Problems
No connection to base
station possible
No telephone calls possible
Connection is disturbed or
cut off
Solutions
− Check that the handset has been regi-
stered on the base station with the
correct PIN code . Page 107.
− The telephone is not connected pro-
perly or is defective. Only use the tele-
phone connection cable supplied.
− Test whether the telephone connec-
tion is in order by using another tele-
phone.
− The power adaptor plug is not plug-
ged in or there is a complete power
failure.
− The rechargeable battery pack is
empty or defect.
− The handset is too far from the base
station.
− Dialling mode is set incorrectly
. Page 107.
− The handset is too far from the base
station.
− The base station is in an unsuitable
location.
The system no longer − Reset all the functions to their default
settings . Page 107.
responds
− Disconnect the power adapter plug
briefly from the power socket.
The battery pack is empty − The battery pack is empty or defect.
in a short time − Place the handset in the base station
properly. Clean the contact surfaces
on the handset and base station with
a soft, dry cloth.
− Place the handset in the base station
for 20 hours.
The caller number display − The caller number display function is
1
(CLIP ) does not function a supplementary service offered by
telephone network providers. Contact
your network provider for further infor-
mation.
− The caller has suppressed the trans-
mission of their phone number.
The answering machine − Ensure that the answering machine is
does not record any mess- connected correctly and switched on.
ages − Check whether the answering ma-
chine memory is full. Delete messa-
ges from the memory, if necessary
. Page 106.
No remote access functions − Check that the correct security code
can be executed has been entered for the remote ac-
cess . Page 106.
− The telephone used for remote access
must be set to Tone dialling mode.
1
CLIP: Calling Line Identification Presentation = Display the caller's
phone number.
In Case of Problems
113