Making The Basic Settings - Sonoro QUBO SO-220 Bedienungsanleitung

Use the [Next ] or [Previous] button to switch between the hours and minutes
display.
After 10 seconds of inactivity, the device automatically goes into Standby mode
without saving the settings.
Setting the date manually
Fig, 11: Setting the date
1. Press the [SETUP] button on the device or the remote control in Standby mode.
W The display shows [Set Time] (Fig. 11)
2. Press the [Next] button.
W The display shows the [Set Date] menu.
3. Press the click wheel.
W You can now set the date according to the same procedure as described
in a 'Setting the time manually' on page 65.
Switching the date on/off
Fig, 12: Switching the date on/off
1. Press the [SETUP] button on the device or the remote control in Standby mode.
W The display shows [Set Time]
2. Press the [Next] button twice..
W The display shows the [Date]menu. (Fig. 12)
3. Press the click wheel.
W You can now switch the date on or off.
7.3

Making the basic settings

When the device is switched on, you can make the following configurations in the
[Settings] menu:
• Set the time format.
• Set the date format.
66
© sonoro audio GmbH 2018