Setting The Basic Functions; Switching On The Device For The First Time; Standby Mode - Sonoro QUBO SO-220 Bedienungsanleitung

7.

Setting the basic functions

The individual menus let you select the functions and settings of the device.
7.1

Switching on the device for the first time

After you have switched the device on for the first time, the LCD display shows the
clock display and the message [Tune to FM RDS station to set time & date].
In FM/DAB mode, time and date are set automatically as long as this has not been
disabled.
7.2

Standby mode

You can adjust the following settings in standby mode:
• Manually set the time.
• Manually set the date.
• Switch the date on the display on/off.
W Setting alarm light (only with sonoroLIGHT). Please see chapter 7.3
'Making the basic settings' on page 66.
The procedure for setting the individual functions is the same.
Setting the time manually
Fig, 10: Setting the time
1. Press the [SETUP] button on the device or the remote control in Standby mode
W The display shows [Set Time] (Fig. 11)
2. Press the click wheel to set the hours.
W The hour display flashes.
3. Turn the click wheel to set the hours.
4. Press the click wheel to confirm the setting.
W The minute display flashes.
5. Turn the click wheel to set the minutes.
6. Press the click wheel to confirm the setting
W The time is set.
© sonoro audio GmbH 2018
GB
65