Setting And Starting A Programme; Cancelling The Programme - Electrolux GA60GLISCN Benutzerinformation

detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.2 Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press or to select a
programme.
• The indicator of the selected
programme flashes.
• The display shows the programme
duration.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
• The programme indicator stops
flashing and comes on with fixed
light.
• The programme duration starts to
decrease with steps of 1 minute.
If you press the on/off button before the
start of the programme, the appliance will
be in programme selection mode when
you activate it again.
Starting a programme with delay
start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
The indicator of the selected programme
continues to flash.
3. Close the appliance door to start the
countdown.
The programme indicator stops flashing
and comes on with fixed light.
• When the countdown is completed, the
programme starts.
• While the countdown is running only
the buttons Reset and Delay are active.
It is not possible to change the
programme or options.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. It may affect
the energy consumption and the
programme duration. When you close the
door, the appliance continues from the
point of interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme will end. This will
not happen when programme
with AutoOpen is
running.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you have
to set the programme and options again.
Press and hold Reset until the appliance
is in programme selection mode.

Cancelling the programme

Press and hold Reset until the appliance
is in programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is completed the
display shows 0:00.
ENGLISH 15