Electrolux GA60GLISCN Benutzerinformation Seite 11

• The display shows the current
setting: e.g.
– The levels of rinse aid are from
0A to 6A.
– Level 0 = no rinse aid is
released.
3. Press again and again to change
the setting.
4. Press the on/off button to confirm the
setting.
6.4 The rinse aid empty
notification
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying to
refill rinse aid. If you are using multi-tabs
containing rinse aid and you are satisfied
with the drying result, you can deactivate
the notification for refilling rinse aid.
However, we recommend that you always
use rinse aid for best drying performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid
empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and start to flash and the display is
blank.
2. Press .
• The indicators
go off.
• The indicator
to flash.
• The display shows the current
setting:
notification is activated (factory
setting).
3. Press to change the setting.
= the rinse aid empty notification is
deactivated.
= level 4.
and until
, ,
, and
continues
= the rinse aid empty
4. Press the on/off button to confirm the
setting.
6.5 MyFavourite
With this option you can set and save the
programme that you use more frequently.
You can only save 1 programme. A new
setting cancels the previous one.
How to save the MyFavourite
programme
1. Set the programme that you want to
save
You can also set applicable options
together with the programme.
2. Press and hold MyFavourite until the
indicators of the programme and the
options flash for a few seconds.
How to set the MyFavourite
programme
Press MyFavourite.
• The indicators that are related to
the MyFavourite programme and
options come on.
• The display shows the duration of
the programme.
6.6 How to deactivate AutoOpen
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and start to flash and the display is
blank.
2. Press .
• The indicators
and go off.
• The indicator
• The display shows the current
setting: = AutoOpen activated.
3. Press
to change the setting:
= AutoOpen deactivated.
4. Press the on/off button to confirm the
setting.
ENGLISH 11
and until
, , ,
,
continues to flash.