Inhaltsverzeichnis
Werbung
INSTALLATION/CONNECTION
3 Installation/Connection
3.1 Installation instructions
Please note the installation of the High Load SHLS80-Q following installation guidelines:
•Attach the unit to the receiving pins (14).
•The minimum distance between two systems in row major order must be at least 100 mm (measuring point system in the
middle).
•The distance of the staple guide the workpiece during stapling operation must be at least 3 mm. We recommend a
height-adjustable mounting of the system.
3.2 Compressed air connection
Explosion hazard
The use of oxygen or other flammable gases as energy sources is strictly prohibited
Explosion hazard!
The connection to the compressed air network is via an air hose with quick coupling (enclosed). The non-closing nipple
should be positioned so that the system the releasing of the connection is immediate pressure. Please note when
connecting to the compressed air system the following points:
•The compressor (compressor) must have sufficient power (min 2000 l /).
•The supplied air must not exceed the max. allowable operating pressure (8.3 bar) for not more than 10% exceed
•Install in the compressed air supply line, a pressure regulator and a shutoff valve.
•Use only filtered, lightly oiled compressed air for operation of the High Load tool.
Run the electrical and pneumatic connections according to plan by.
Info
The trigger pulses must be at least 0.05 s rest.
OPERATING
4 Operating
4.1 Filling the quick change magazine
Info
We recommend the filling of the quick-change magazine (11) only during breaks or at standstill to download
the apparatus or production line.
Place the clamp rods lying with the leg opening to the open side of the Quick-change magazine, from the top.
4.2 Filling of the central lubrication system
Image 4.2/1: Central lubrication system
Bild 4.2/1: Zentralschmieranlage
A A 8
A A 7
A A 1
A A 2
A A 3
A A 4
A A 5
A A 6
GB
7
7
Werbung
Kapitel
Inhaltsverzeichnis
