Starting Up - switel DE102 Bedienungsanleitung

2

Starting Up

2.1 Safety information
Caution: It is essential to read the Safety Information in Chapter 1 before starting up.
2.2 Checking the contents of the package
The package contains:
a base station with power adapter plug
two handsets
a charging station with power adapter plug
2.3 Connecting the base station
Connect the base station as illustrated in the dia-
gram. For reasons of safety, only use the power
adapter plug and telephone connection cable sup-
plied. The power adapter plug from the base station
must always be connected to a properly installed
230 V mains power outlet.
2.4 Connecting the charging station
Connect the charging station as illustrated in the dia-
gram. For reasons of safety, only use the power
adapter plug supplied.
2.5 Inserting the batteries
Insert two batteries of the type AAA Ni−MH 1.2 V 550 mAh in the bat-
tery compartment after opening it. Pay attention to correct polarity
(refer to Fig.). Close the battery compartment cover.
Important: Do not use any other type of batteries.
2.6 Charging the batteries
When preparing to use the handset for the first time, place it in the base station (display facing up-
wards) for at least 14 hours. The charging control lamp on the base station lights up. The handset
warms up during the charging process. This is normal and does not represent a risk. Do not
charge the handset with charging units from other manufacturers. Failure to charge the batteries
properly can lead to telephone malfunction.
The current battery charge status is indicated in the display:
Full
2.7 Tone or Pulse dialling mode
The telephone can be connected to both analogue connections (pulse dialling) and digital con-
nections (tone dialling). The equipment is set to Tone dialling mode at the factory. If the telephone
does not work on your telephone connection, refer to Chapter 7.3 to learn how to switch the tele-
phone to analogue, pulse dialling mode.
2.8 Operating on private branch exchanges
If your telephone is connected to a private branch exchange, use the R button to implement
the transfer calls or automatic callback functions. When used on a private branch exchange, a Re-
call time of 90 ms must be set. The sales outlet where you purchased the telephone can tell you
whether it will work on your private branch exchange.
2.9 Supplementary services from your telephone network provider
The SWITEL telephone supports all major supplementary services offered by the telephone net-
work provider (e.g. brokering, call waiting, three−way conferencing, etc.). Press the R button
to use these services. Please contact the telephone network provider with regard to enabling the
supplementary services.
78
− Starting Up −
a telephone connection cable
four rechargeable batteries
an operating manual
Half empty
230 V
50 Hz
TAE−F
230 V
50 Hz
Low Empty