General Information; Setting Up; Check Contents Of Pack; Connecting The Receiver - switel RETROTEL t1896 Bedienungsanleitung

1.

General information

Position
There must be a 230 Volt mains socket near to where the telephone is positioned. Do not set
up the base station in the immediate vicinity of other electrical equipment such as
microwaves or hi-fi systems, as this may result in mutual interference. The location has a
decisive influence on the trouble-free operation of the telephone.
Place the base station on a flat and non-slip surface. The feet of the base station do not
normally leave any marks on the surface. However, due to the large number of varnishes and
surfaces in use, it may not be possible to prevent marks occurring on the surface due to the
feet of the unit.
Do not use the handset in areas where there is a risk of explosion.
Excessive exposure to smoke, dust, vibrations, chemicals, moisture, heat or the direct rays of
the sun must be avoided.
Temperature and Ambient Conditions
The telephone is designed for use in protected rooms with a temperature range of 10 °C to
30 °C.
The base station must not be installed in damp rooms such as a bathroom or laundry room.
Avoid proximity to sources of heat such as radiators and do not expose the unit to direct
sunlight.
Cleaning and care - The surface of the case can be cleaned with a soft, dry, lint-free cloth.
Never use cleaning agents, particularly aggressive solvents. No attention is necessary apart
from cleaning the case occasionally. The rubber feet of the base station are not resistant to
all cleaning agents. The manufacturer can therefore not accept any liability for possible
damage to furniture or the like..
2.

Setting Up

2.1

Check contents of pack

The following items are supplied:
one telephone base
one telephone connecting cable
2.2

Connecting the receiver

After unpacking your telephone, you must first connect the telephone receiver
to the telephone base. Take the end of the spiral cable and plug it into the
socket of the telephone base.
2.3

Connecting the telephone

Connect the telephone cable supplied to the telephone socket and the telephone
jack of the telephone base. The telephone works using the MF system (Tone
Dialling).
- RETROTEL T1896 -
one telephone receiver with cable
one instruction manual
9